Make sure you have connected the receiver to your router using the included Ethernet cable.Make sure the receiver shows a green network icon on the LCD display.If the icon is red, you may need to turn the unit off and on again. The memory card has been removed from the receiver.Video streams in live viewing are different sizes Insert a memory card with motion recordings stored on it into the receiver to view events on your smartphone / tablet. Cameras are set to different resolutions (i.e., one is set to VGA and the other to HD).Make sure the adapter is plugged in and the red LED light on the power adapter is on Lorex LW2902 security camera troubleshooting The system will record each resolution normally. Make sure that the Cameras and Receiver are both ON.Make sure that the camera is in range of the Receiver.There is Interference with the Camera Picture. Make sure that each camera is within range, and that there are no large obstructions or interference.The picture may become choppy when experiencing a lower frame rate (i.e.Remove obstructions between the Receiver and Camera.The Picture appears to be grainy/distorted Resolution will be reduced but video frame rate will increase When using with large screen TV/Monitor (especially high- definition televisions), the picture might be grainy as the camera limits video resolution to VGA (640x480 pixels).For best performance use with TV/Monitor PIP (Picture in Picture) function.
View video on a smaller screen TV/Monitor.Ĭheck your TV/Monitor product manual to see if this feature is available on your TV/Monitor.Consider increasing the range of the wireless signal with an accessory antenna.DO NOT point your camera towards a liqht source.The system has encountered an error with the SD card.Power off the receiver, remove then re-insert the SD card, and then power the receiver back on
Lorex NTSC security camera troubleshooting and U buttons jump to their respective channels while in Quad Mode press the CHANNEL-M button on the remote control or the receiver to change channels manually Please check the video signal line connection.
0 kommentar(er)
